Port Status/Control

View PHY

[port <int>] phy show

Property	Type	Description	Required?
`port`	`int`	Switch port with PHY	✅

Available on v1.2.0 or higher.

[port <int>] phy set [autoneg {"off", "on"}] [speed <int>] [duplex {"full", "half"}]

Property	Type	Description	Required?
`port`	`int`	Switch port PHY number	✅
`autoneg`	`string`	String literal describing whether the port’s PHY should enable auto-negotiation.	❌
`speed`	`int`	PHY speed if auto-negotiation disabled. Must be (10, 100, 200, 1000, 2500, 5000, 10000). Required if auto-negotiation is disabled.	❌
`duplex`	`string`	PHY duplex if auto-negotiation disabled. String literal must be `“full”` or `“half”`. Required if auto-negotiation is disabled.	❌

Available on v1.2.0 or higher.

[port <int>] phy set [advertise <int> <int> ...]

Property	Type	Description	Required?
`port`	`int`	Switch port PHY number	✅
`advertise`	`List[int]`	The advertised link modes supported by the PHY. You can add support for multiple link modes by providing a list of ints.
`0x01` - 10BaseT half
`0x02` - 10BaseT full
`0x04` - 100BaseT half
`0x08` - 100BaseT full
`0x10` - 1000BaseT half
`0x20` - 1000BaseT full	❌

Available on v1.2.0 or higher.

*Currently only available on UbiSwitch

[port <int>] temperature

Property	Type	Description	Required?
`port`	`int`	Switch port PHY number	✅

Available on v0.3.1 or higher.

*Currently only available on UbiSwitch

[port <int>] eee [{"on", "off"}]

Property	Type	Description	Required?
`port`	`int`	Switch port PHY number	✅
`eee`	`string`	`on` for advertise EEE to link partner, `off` for no advertisement EEE to link partner	✅

Available on v0.4.0 or higher.

[port <int>] phy power {"on", "off"}

Property	Type	Description	Required?
`port`	`int`	Switch port number	✅
`power`	`string`	Power state of the PHY. String literal must be `"on"` or `"off"`	✅

Available on v1.0.0 or higher.

[port <int>] sfp

Property	Type	Description	Required?
`port`	`int`	Switch port number	✅

Available on v1.0.0 or higher.

Table of Contents