Hardware setup

This section describes per board and baseboard information on how to connect and use the CLI for BloxOsLite

UbiSwitch / UbiSwitch NDAA setup

SwitchBlox Industrial / SwitchBlox Industrial NDAA setup

CLI Bringup

Follow the steps below to access the CLI

1. Connect the UART port on your baseboard to your computer, either directly or via a USB-to-UART converter.
   1. Connect GND , RX and TX lines. Do not connect 3V3 to any pin on the USB-to-UART converter.
2. Open a serial terminal program (plain terminal using screen or GUIs like TeraTerm are fine). with the following parameters
   • Type: Serial
   • Baud Rate: 115200bps
   • Parameters: 8 data bits, no parity, 1 stop bit (8-n-1)
3. Power on the board and wait 5 seconds for the serial recovery LED to turn off.