1. Click the Enable Port Mirroring button.
2. Select which port will be the snooping port. This port will be the port that receives all the mirrored traffic to send out of the ethernet switch.
3. For Mirror Mode, select “Mirror RX and TX”. You should usually only use this setting.
4. Select which TX and RX from which ports you would like to be mirrored onto the Snooping port. TX refers to egress traffic sent out of the switch, whereas RX refers to ingress traffic sent into the switch.
5. Click Write Config. The LED should illuminate green if the write was successful.
6. Click Read Config to read back and confirm what was written to the device. The UI elements should not change, indicating that the values read back from the device are the same as what was just written.